TS1 type thermal hydrodynamic pumps

TS1 type thermal hydrodynamic pumps are modern, high-efficiency, self-contained, energy-saving, ecologically friendly heating, heat supply and hot water supply systems. They are intended for: - autonomous heating residential, office, sport, industrial and storage buildings, greenhouse, etc; - heating of water for: household and technological purposes, bathhouses, laundries, pools, etc. Thermal hydrodynamic pumps have many advantages: generate pollution-free heat, can be used in seismically danger zones, they are explosion- and fire-proof, irreplaceable in mountain area with terrace site development, can work as a complex with wind power stations and small hydrostations. In the nighttime the pumps with heat accumulators allow to use free electric power at the minimum prices. Commercial products (TU 3631-001-78515751-2007, Certificate of conformity # ROSS RU.AYa46.V12043) - TS1 type thermal hydrodynamic pumps - represent the standard induction motor of 3000rpm, supply voltage 380V, skid-mounted with a heat-generator, transforming mechanical energy into thermal energy. They are completely ready for connection to a new or existing heating system, and the design and dimensions of the thermal hydrodynamic pump simplify its disposing and mounting in a heat supply unit. For reliability it is recommended to apply at least two thermal hydrodynamic pumps in a heat supply unit. Preliminary selection of the thermal installations power applied for heating is executed by the specification - 1kW supplied thermal energy per 10sq.m of heated area (for Moscow region rated air temperature – 26°С within a week). Selection of the thermal hydrodynamic pump power is executed by the specification - 1kW of the electric motor installed capacity per 30sq.m of heated area. Thermal hydrodynamic pumps must heat conditional typical (matching the requirements of Construction regulations) residential, household, cultural-entertaining premises, premises of industrial-economic purposes, etc., of the volume: TS1-055 – 5180m3, TS1-075 – 7060m3, TS1-090 – 8450m3, TS1-110 – 10200m3 (the thermal hydrodynamic pump marking specifies the installed capacity of the used electric motor). Necessary temperature mode can be maintained in heated premises. For example, 20 - 22°C for living spaces, 15 - 18°C – industrial spaces, 8 - 12°C – warehouse. Temperature mode regulating is made by setting the heat carrier temperature range on the control panel. As heat carrier heats up to the set maximum temperature the thermal hydrodynamic pump turns off, as heat carrier cools to the minimum set temperature – turns on. It is generated exactly as much thermal energy as much heat loss of a heated object. During winter periods the operating time is more and less for autumn-spring periods. For the average heating season (for Moscow region it makes 210 days) the equipment operates 25-30% of time (see Table 1). Therefore we apply factor Koper. = 0.3 to preliminary calculation of financial expenditure for heating. Automatics allow to make change-over of a temperature mode within a minute. In the evening a duty engineer can lower temperature in premises and before the beginning of working day set comfortable temperature in premises again. It allows additionally lower heating cost at least on 35%.